12-15-2020 12:53 AM
Hi,
When FMC active goes down,the standby do not become active. any solution for this issue.
12-15-2020 01:35 AM
I see otehr post you having issue with FTD same issue, are you having issue with FMC or FTRD
if both then we need to look your HA or other Links how these connected.
12-15-2020 02:03 AM
Hi balaji,
Thanks for response. as of now the secondary is down due to maintenance activity.
i can share below details. The FMC interfaces also in the port channel.
#show failover
interface Port-channel12
description LAN/STATE Failover Interface
failover
failover lan unit primary
failover lan interface Failover Port-channel12
failover replication http
failover link Failover Port-channel12
failover interface ip Failover 192.168.0.1 255.255.255.252 standby 192.168.0.2
peer poll time - 1 sec
peer hold time - 15 sec
interface poll time - 5 sec
interace hold time - 25 sec
The both FTD connected each other. we have a port channel for 2 interface. each interface has 10G capacity.
show high-availability config
Failover On
Failover unit Primary
Failover LAN Interface: Failover Port-channel12 (Failed - No Switchover)
Reconnect timeout 0:00:00
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 4 of 1041 maximum
MAC Address Move Notification Interval not set
failover replication http
Version: Ours 9.12(2)33, Mate Unknown
Serial Number: Ours xxxxxxxxxx, Mate Unknown
Last Failover at: 00:05:55 UTC Jan 1 2010
This host: Primary - Active
Active time: 1197183 (sec)
slot 0: UCSB-B200-M3-U hw/sw rev (0.0/9.12(2)33) status (Up Sys)
Interface srv0 (10.1.1.1): Normal (Not-Monitored)
Interface srv1 (10.2.2.2): Normal (Waiting)
Interface srv2 (10.3.3.3): Normal (Waiting)
Interface srv3 (10.4.4.4): Normal (Waiting)
Interface srv5 (10.5.5.5): Normal (Not-Monitored)
Interface srv6 (10.6.6.6): Normal (Not-Monitored)
Interface srv7 (10.7.7.7): Normal (Not-Monitored)
Interface srv8 (10.8.8.8): Normal (Not-Monitored)
Interface srv9 (10.9.9.9): Normal (Not-Monitored)
Interface srv10 (10.10.10.10): Normal (Not-Monitored)
Interface srv11 (10.11.11.11): Normal (Not-Monitored)
Interface diagnostic (0.0.0.0): Unknown (Waiting)
slot 1: snort rev (1.0) status (up)
slot 2: diskstatus rev (1.0) status (up)
Other host: Secondary - Failed
Active time: 0 (sec)
Interface srv0 (0.0.0.0): Unknown (Not-Monitored)
Interface srv1 (10.1.1.2): Unknown (Waiting)
Interface srv2 (10.2.2.3): Unknown (Waiting)
Interface srv3 (10.3.3.4): Unknown (Waiting)
Interface srv4 (0.0.0.0): Unknown (Not-Monitored)
Interface srv5 (0.0.0.0): Unknown (Not-Monitored)
Interface srv6 (0.0.0.0): Unknown (Not-Monitored)
Interface srv7 (0.0.0.0): Unknown (Not-Monitored)
Interface srv8 (0.0.0.0): Unknown (Not-Monitored)
Interface srv9 (0.0.0.0): Unknown (Not-Monitored)
Interface srv10 (10.11.11.12): Unknown (Not-Monitored)
Interface diagnostic (0.0.0.0): Unknown (Waiting)
slot 1: Not Ready
slot 2: Not Ready
Stateful Failover Logical Update Statistics
Link : Failover Port-channel12 (Failed)
Stateful Obj xmit xerr rcv rerr
General 0 9 0 0
sys cmd 0 0 0 0
up time 0 0 0 0
RPC services 0 0 0 0
TCP conn 0 0 0 0
UDP conn 0 0 0 0
ARP tbl 0 0 0 0
Xlate_Timeout 0 0 0 0
IPv6 ND tbl 0 0 0 0
VPN IKEv1 SA 0 0 0 0
VPN IKEv1 P2 0 0 0 0
VPN IKEv2 SA 0 0 0 0
VPN IKEv2 P2 0 0 0 0
VPN CTCP upd 0 0 0 0
VPN SDI upd 0 0 0 0
VPN DHCP upd 0 0 0 0
SIP Session 0 0 0 0
SIP Tx 0 0 0 0
SIP Pinhole 0 0 0 0
Route Session 0 0 0 0
Router ID 0 0 0 0
User-Identity 0 0 0 0
CTS SGTNAME 0 0 0 0
CTS PAC 0 0 0 0
TrustSec-SXP 0 0 0 0
IPv6 Route 0 0 0 0
STS Table 0 0 0 0
Umbrella Device-ID 0 0 0 0
Rule DB B-Sync 0 0 0 0
Rule DB P-Sync 0 0 0 0
Rule DB Delete 0 9 0 0
Logical Update Queue Information
Cur Max Total
Recv Q: 0 0 0
Xmit Q: 0 0 0
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide