We have two networks connected over ADSL point-to-point connection(actually one side is MetroEthernet). Lets say A and B networks. On both sides there are Pix 501 and Pix515 respectively. There are computers located in A with i.e. 10.0.0.1/24, 10.0.0.2/24.. And in network B there is also a computer with the same subnet configuration. (i.e. 10.0.0.3/24), all computers do not have gateway addresses congfigured and they try to communicate each other over NetBIOS. So What i need to try is to connect the PC in B to A over this firewalls. Please note that it is almost impossible to change IP configuration of PCs. Is this possible??
As far as I know 6.x will not support the transparent firewall feature from 7.x.
The way to do it is with routers and GRE tunnel.
Please rate if this helped.
Regards,
Daniel
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
