Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I am trying to implement QoS in a frame relay connection, i am configuring on the side where the jam occurs. But i could not see any improvement in the quality. what may be wrong ? Below there is my configuration:class-map match-all voice-tr...
DearsWe have two networks connected over ADSL point-to-point connection(actually one side is MetroEthernet). Lets say A and B networks. On both sides there are Pix 501 and Pix515 respectively. There are computers located in A with i.e. 10.0.0.1/24, 1...
HiWe are using AS5400s in our voip network and an other vendors sip proxy. We have a problem about PRACK message. Our proxy sends an absurd PRACK message and calls drop. To solve this i searched for disabling PRACK message in 5400s, but i couldn't fi...
HiCan we use AS5400 NP108 or NP60 cards in AS5350 also? Are they same? Their names are different but i guess they might be same cards, are there any body who experienced this?Best Regards.deniz
HiI have a router switch twain with vlans configured. From one of my subinterface i have configured ip address dhcp (i also tried ip address dhcp client-id etc), however i can not get ip address. When i configure without vlan and connect the etherne...
I do not have Auto Qos in my ioses they are 12.3 and 12.2. The quality is poor in the sense that packets are lost or like orders changed. It appears on the remote end, unidirectional. That is to say; there are two sides, my side and customer side. cu...
Dear MartinThanks for your fast response!! I have configured "match protocol rtp audio " but no change in the voice quality. Actually i am using Cisco ATA behind the router so i am sure about that cisco uses 16384 udp as voice port. Also i get the s...
