01-04-2007 01:53 AM - edited 03-11-2019 02:15 AM
Dears
We have two networks connected over ADSL point-to-point connection(actually one side is MetroEthernet). Lets say A and B networks. On both sides there are Pix 501 and Pix515 respectively. There are computers located in A with i.e. 10.0.0.1/24, 10.0.0.2/24.. And in network B there is also a computer with the same subnet configuration. (i.e. 10.0.0.3/24), all computers do not have gateway addresses congfigured and they try to communicate each other over NetBIOS. So What i need to try is to connect the PC in B to A over this firewalls. Please note that it is almost impossible to change IP configuration of PCs. Is this possible??
Best Regards,
Deniz
01-10-2007 07:15 AM
What version of software does your pix box run?
01-11-2007 12:12 AM
6.3.1 and 6.3.5
best Regards,
Deniz
01-11-2007 10:02 AM
Hi,
As far as I know 6.x will not support the transparent firewall feature from 7.x.
The way to do it is with routers and GRE tunnel.
Please rate if this helped.
Regards,
Daniel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide