FP1100 Firepower network port is not getting active

rajeesh.mariyodan · ‎03-04-2022

This is standalone firewall not connected to internet:

I am started in Cisco devices , i have configured the ciscso firewall and connected the network cable .

But not able to enable the port , port was enable from the web gui.

Please find the attached photos , how to get the port 5 acive

Rob Ingram · ‎03-04-2022

@rajeesh.mariyodan I assume you've deployed the policy to the FTD?

rajeesh.mariyodan · ‎03-04-2022

Yes policy was already deployed , is there anything else i need to do to enable the network port .

As port 5 when network cable , LED also not even flashing.

Rob Ingram · ‎03-04-2022

@rajeesh.mariyodan ok, just checking.

That's all you need to do to enable the interface, have you tried enabling another port? Same issue?

Have you replaced the cable?

Have you tried using a different interface on the switch?

rajeesh.mariyodan · ‎03-04-2022

When the device was switch on it was configurated with enabled with inside and outside port.

I have connected same switch and cable to port 2 then its showing green color .

Attached some more configuration .

rajeesh.mariyodan · ‎03-04-2022

i did some more try , i have pressed discard - due to this all my setting lost and become base seeting when firewall was powered on

As i am getting deployment error every time

rajeesh.mariyodan · ‎03-05-2022

Looks like changed done is not able to deployed to the firewall , may be issue related to below bug .