cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1732
Views
0
Helpful
2
Replies

FPR 1010 connected client not getting DNS

mickyq
Beginner
Beginner

out of the box setup using FDM and the client device or the management device dont get DNS.

manually enter a DNS IP in the client NIC properties and DNS lookups work. I can browse the internet. The same applies for the device on the management port.

how does the client get DNS settings. DHCP works ok but no DNS settings pulled through to client device.

 

thanks

 

2 Replies 2

mickyq
Beginner
Beginner

Found the problem.

Go into DHCP>Configuration and either add some DNS IP's or hit the use opendns button.

why is there a DNS server config if it does not get used?

Ruben Cocheno
Enthusiast
Enthusiast

@mickyq 

 

By default could have the DNS servers setup, but unfortunately is not the case.

Please mark it helpfull if it was the case, and i have this problem too. Double touchdown is amazing. Thanks to make Engineering easy.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: