cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
464
Views
0
Helpful
1
Replies

FTD 7.1.0-61 in GNS3 interfaces down no packets received

hmc2500
Level 1
Level 1

I'm trying to get FTD 7.1.0-61 (with FMC 7.1.0-61) configured in GNS3 (ver 2.2.37) but interfaces are down (no packets received). Ive set the interface status in Health policy to disabled. The outside interface is set to DHCP but not receiving an ip address. Inside interface is manually assigned an ip address however that too is showing down. Status and protocol are showing down (not administratively down) in show interface ip brief on the FTD. The GNS3 NAT connector is leasing out ip addresses, I've tested that with another machine. Any idea how to fix this?

 

hmc2500_0-1675800705503.png

 

1 Reply 1

balaji.bandi
Hall of Fame
Hall of Fame

what switch you using in switch, may be after config reload the device and test it.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Review Cisco Networking for a $25 gift card