- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-01-2025 11:52 AM
We've recently added a new FTD 1120 to our FMC and during this process, apparently something was done differently, as there is now a Chassis URL in the Chassis column in Device Management in FMC. There doesn't seem to be any problem with the device's functionality, so I am thinking it is largely only a cosmetic thing. Is there a way to remove this? I have found details on how to change Chassis names, but this seems to be a different sort of issue. I'd also like to understand how this happened, as it didn't occur the last time we added an FTD a couple of months ago.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-02-2025 07:53 AM
It's a cosmetic bug on the 1000 series. Fixed in 7.7.0 (and should be included in the upcoming 7.6.1).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-01-2025 03:20 PM
It is a cosmetic bug that does not impact the deployment. I don't have the bug ID handy but I think @Marvin Rhoads might.
Thank you for rating helpful posts!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-02-2025 07:53 AM
It's a cosmetic bug on the 1000 series. Fixed in 7.7.0 (and should be included in the upcoming 7.6.1).
