About robo764

robo764 · 07-16-2024

On one of our sites, we have a Firepower 2110 configured for WCCP. Previously, it's WCCP Router ID was an unused ethernet port that was configured with an IP address, but not physically connected to anything. It was this way, when I inherited, so I...

robo764 · 06-13-2024

From what I understand, the Catalyst 9400 series does not currently have quad-supervisor support when configured with StackWise Virtual. In the documentation, it states: "The in-chassis standby Supervisors if available will be powered-off by the syst...

robo764 · 06-12-2024

I just have a quick question that I wasn't able to find an easy answer for. When I browse the software available for download for our C9410R, I have 6 options: 1 "Software on Chassis" and then 5 options for different Supervisor Engines. For each of t...

robo764 · 05-20-2024

When I tried to register for the SNTC Portal, I received the following message:"Your user profile does not have complete address. Please update your Cisco Account profile with the complete address.After updating your Cisco Account profile , rest...

robo764 · 04-19-2024

I've recently inherited a new network as part of beginning a new job. Historically, my exposure to voice is pretty limited. Without getting into the details of what lead to it, as it's not relevant, after performing a reset on an 8851, the phone gr...

robo764 · 07-17-2024

"For WCCP to work, the interface whose IP address is chosen as the router ID must be in the UP state and there must be a route to the device."Yeah, this is what was throwing me off. I couldn't find a firepower-specific document that talked about WCCP...

robo764 · 07-17-2024

As a ridiculous/maddening coincidence, the tunnel interface (that was just recently selected as the new WCCP Router I went down last night. As a result, the WCCP Router ID reverted back to the down/down ethernet interface. So the firepower is now u...

robo764 · 05-30-2024

I was able to "access" the portal, but the page does not format properly, and I receive additional errors. I first receive a "blank" pop-up (see first attachment), and no matter what I do (click "OK," click the "X" to close, or click outside the box...

robo764 · 05-21-2024

The information on the page was correct, but I clicked the Update button and received confirmation that it was updated/validated (see attached screenshots). Upon attempting registration, again, I received the same message.

robo764 · 05-08-2024

In this particular case, the issue seems to be with a couple of old Cisco ATA 191s. They were no longer in use, but were somehow being forwarded traffic that should have been sent to phones. There were two of them, which would correspond to the two...

Member Since	‎04-19-2024 05:26 AM
Date Last Visited	‎07-23-2024 01:04 AM
Posts	11

User Statistics

User Activity

WCCP Router ID Change on Firepower 2110

Behavior of StackWise Switch During SUP Failure

Difference in Available/Recommended Software

Unable to Register with SNTC Portal - "Complete Address" error

One-way Audio following IP Address Change

Re: WCCP Router ID Change on Firepower 2110

Re: WCCP Router ID Change on Firepower 2110

Re: Unable to Register with SNTC Portal - "Complete Address"

Re: Unable to Register with SNTC Portal - "Complete Address"

Re: One-way Audio following IP Address Change