Solved: FTD running and startup version is different.

anilkumar.cisco · ‎07-22-2021

my FTD 4100 show Running version 6.2.3.16.59 and start-up version is showing 6.2.0.363.

Any clue or issue , as we are planning for FXO upgrade..

Marvin Rhoads · ‎07-22-2021

Startup is the image used when the FTD logical device was first instantiated from the chassis manager.

Running version is what's important and is fine that it's a newer version.

FXOS can still be upgraded with that condition. Also be sure to check your firmware - version 1.0.19 should be used per the field notice that's out of the 4100 and 9300 series.

It would be a good idea to get your FMC and FTD both upgraded to the current recommended version of 6.6.4 after you've finished with FXOS upgrades. Version 6.2.3 is quite old by now.

View solution in original post

Marvin Rhoads · ‎07-22-2021

Startup is the image used when the FTD logical device was first instantiated from the chassis manager.

Running version is what's important and is fine that it's a newer version.

FXOS can still be upgraded with that condition. Also be sure to check your firmware - version 1.0.19 should be used per the field notice that's out of the 4100 and 9300 series.

It would be a good idea to get your FMC and FTD both upgraded to the current recommended version of 6.6.4 after you've finished with FXOS upgrades. Version 6.2.3 is quite old by now.