02-07-2012 09:22 PM - edited 03-11-2019 03:25 PM
Hi,
How can i open both tcp and UDP ports for an IP in Cisco ASA?
Regards
Ejaz
02-07-2012 10:22 PM
Are you referring to port opening in Cisco ASA to permit certain traffic? I believe the following document should help.
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/acl_overview.html
Adding a Standard Access List
hostname(config)# access-list access_list_name standard {deny | permit} {any | ip_address mask}
Example:
hostname(config)# access-list OSPF standard permit 192.168.1.0 255.255.255.0
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/acl_standard.html
Adding an Extended Access List
access-list access_list_name [line line_number] [extended] {deny | permit} protocol source_address mask [operator port] dest_address mask [operator port | icmp_type] [inactive]
Example:
hostname(config)# access-list ACL_IN extended permit ip any any
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/acl_extended.html
Hope this will help.
02-08-2012 04:50 AM
What is the ASA IOS Version? The command syntax will be different for pre and post 8.3 versions.Please check the ASA command reference guide for your IOS or post your exact requirement along with sanitized configs from ASA. Someone will be able to help you with the configs.
Thx
MS
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide