Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
778
Views
0
Helpful
1
Replies

How can I switch the active ASA to standby?

whiteford
Level 1
Level 1

‎12-22-2008 11:14 AM - edited ‎03-11-2019 07:28 AM

Hi,

I have 2 ASA's in failover mode, how can I use the ASDM and CLI to switch the Active ASA to standby so the Standby ASA kicks into Active mode?

Thanks

Labels:
0 Helpful
1 Reply 1

ajagadee
Cisco Employee
Cisco Employee

‎12-22-2008 11:15 AM

The no failover active command is entered on the active unit, or the failover active command is entered on the standby unit.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Regards,

Arul

*Pls rate all helpful posts*

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card