08-10-2008 06:48 PM - edited 03-11-2019 06:29 AM
Hi,
i loss the Cisco ASA 5510 IOS software, may i know the procedure to install back again the IOS software.
Thanks A lot.
-Gilbert
Solved! Go to Solution.
08-10-2008 11:43 PM
on the r mon
u need to put one of ur ethernet of the firewall connected with a PC that contain TFTP service runing
and make the PC and the firewall interface in the same subnet and give then IPs
inn the rmon
define the TFTP as the PC address and give the firewall address and also define the path with image name
just follow the following link
http://www.cisco.com/en/US/ts/fn/620/fn62378.html
good luck
please, if helpful Rate
08-10-2008 08:34 PM
Here is basic procedure via ASDM or CLI
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008067e9f9.shtml
HTH
Jorge
08-10-2008 08:38 PM
those two links will help alot
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008067e9f9.shtml
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708d8.shtml
good luck
please, if helpful Rate
08-10-2008 10:24 PM
Hi,
How about if my ASA no more image file, when boot up it will direct go to rommon.
thks
-Gilbert
08-10-2008 11:43 PM
on the r mon
u need to put one of ur ethernet of the firewall connected with a PC that contain TFTP service runing
and make the PC and the firewall interface in the same subnet and give then IPs
inn the rmon
define the TFTP as the PC address and give the firewall address and also define the path with image name
just follow the following link
http://www.cisco.com/en/US/ts/fn/620/fn62378.html
good luck
please, if helpful Rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide