Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I already a end point devices which only supported 802.11b which like to join the Wireless with Access Point 1832i, as Cisco recommendation i did turn off the 1 - 11mbit data rate which cause this endpoint devices unable to join the wireless netw...
Hi, i created a ipsec tunnel but i'm fail to connect to the Peer side, i enable the debug and found some error but i dunno what is that means? need help!PNG-FW(config)# Apr 21 18:11:31 [IKEv1]: Group = 147.178.7.132, IP = 147.178.7.132, QM FSM error ...
Hi,At first i install the LMS 3.0 with the evaluation license. After that we succesful register the license and got the activation key from cisco,but while trying to update this new activation key into my LMS server it prompt me the error "Could not ...
Hi Leo, Yes that is a medical devices end point. i did brought the devices and tested in my lab test wlc controller with 1042N access point with only turn mandatory on 11mbps data rate and it was working fine. i saw the end points connected as 802.11...
Hi,If i wanna use the Cisco 3600 as the cisco unified communication manager is it i need to add in additional card, from the documentation i saw that we need the voice nm card.Is it correct?-Gilbert
Hi java,Thks,Anyway what is the function for Voice 2V, which i have together with the 3600 router ?if i download the cucme, then is it any extra module i need on it ?Thks -Gilbert
Hi Java, Thks a lot, another help is it can send me the link for what requirement for me to set up the Cisco Voice environment. So i can get the more clearance picture on it.Thks -Gilbert
