How to view port-channel status in Firepower device

[Mri_Mo]

how to check the port-channel status & associated interface details in FTD. when i login to the device, it lands in the below mode/console;

Firepower-module1>

[balaji.bandi]

Look at the below guide for reference and commands :

https://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/215351-configure-verify-and-troubleshoot-port.html#anc6

[Mri_Mo]

Thanks for the document. i could see that only from the FXOS we will be able to see the port-channel summary. Unfortunately im not able to login to FXOS. When i login, it shows the module page, from there i can execute connect FTD, not connect FXOS command or login to EXEC mode;

Firepower-module1>connect fxos
No VM CSP running/Invalid VM CSP name: fxos
Firepower-module1>

Any suggestion for this

[Mri_Mo]

Found that there was an chassis IP & logging with that I was able to execute the commands in the link provided by you.. Thanks @balaji.bandi for your assistance

[balaji.bandi]

Due to CV-19 reply may be delayed, good it was useful.

if this resolved mark as resolved so other community users can refer the same.