IDSM-2 Upgrade

[dinesh.das]

Hi,

I am upgrading IDSM-2 image from v5 to v6 (IPS-K9-6.0-4a-E1.pkg) after this upgrade do we need to go for the Upgradation of Recovery Partition ?

Thank you,

Dinesh

[dinesh.das]

Hi,

Every thing is same as shown in document, but i am not able to see any logs, If i keep same vlan on SPAN logs are there.

Any trouble shooting steps or tools are there ?

[Farrukh Haroon]

If you Inline VLAN Pair is not functional, then no traffic will pass through anyway. You can try to ping between any two devices in the 'bridged' VLANS.

Regards

Farrukh

[dinesh.das]

My configuration is like this,

firewall vlan-group 2 10,100

Vlan 10 Inside & Vlan 100 is outsie interface of the FW Context,

I created on L2 Vlan 101

and added this VLAN (10 and 101) in VLAN PAIR config and this interface giga 0/8.1 (Subinterface). same interface is config for Virtual Sensor 0.

I dont have problem with traffic but not able to see any logs.

[dinesh.das]

Hi

[Farrukh Haroon]

In which mode is the sensor operating?

Auto/Bypass etc.

Regards

Farrukh

[dinesh.das]

It is in Auto (Bypass inspection when analysis engine is stopped.)

Is this will create a problem ? or do we need to change it to ON & OFF.

[Farrukh Haroon]

Nah Auto is fine. Can you post the configs? (show config)

Regards

Farrukh