08-12-2012 10:16 PM - edited 03-11-2019 04:41 PM
Existing nework
New Network
Hi all,
I have attached some diagram here,
2911 Router configured as a zone based firewall and it works fine.
I need to put ASA 5510 as an internal Firewall in to the existing network.
So I need to hand-over the NATing configuration from IOS FW to ASA 5510 , are there any special configs here? I have done this but it's not working,
If i bypass IOS ZB FW and ASA directly connect to internet Its works fine,
If NAT configurations keep in IOS ZB FW then it works fine.
I have attached IOS ZB FW current config file below.
If u can pls guide me solve this problem....
08-12-2012 11:08 PM
Hello Namal,
I think we will need to check the ASA configuration as that might be the one is causing the problems with the router.
Right now on the ZBFW I can stil see the NAT statement for the public addresses, so what is the NAT you are going to perform on the ASA
08-12-2012 11:10 PM
I will attach asa configurations too...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide