08-12-2012 10:16 PM - edited 03-11-2019 04:41 PM
Existing nework
New Network
Hi all,
I have attached some diagram here,
2911 Router configured as a zone based firewall and it works fine.
I need to put ASA 5510 as an internal Firewall in to the existing network.
So I need to hand-over the NATing configuration from IOS FW to ASA 5510 , are there any special configs here? I have done this but it's not working,
If i bypass IOS ZB FW and ASA directly connect to internet Its works fine,
If NAT configurations keep in IOS ZB FW then it works fine.
I have attached IOS ZB FW current config file below.
If u can pls guide me solve this problem....
08-12-2012 11:08 PM
Hello Namal,
I think we will need to check the ASA configuration as that might be the one is causing the problems with the router.
Right now on the ZBFW I can stil see the NAT statement for the public addresses, so what is the NAT you are going to perform on the ASA
08-12-2012 11:10 PM
I will attach asa configurations too...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: