Network Security

Hi everybodyI'm trying to configure failover in two pix 515E following the instructions of the Installation Guide. I've connected the failover cable properly (not using Stateful Failover) but when I write "show failover" in the CLI of the primary uni...

Hi,our need is this: To allow access to a TS server when requests for 3389 are sent to the outside of the PIX. To direct all other traffic (VPN/Email/FTP etc) to our existing authentication server. I have updated the PIX software to allow port redire...

I was wondering if the metric keyword in the statis route command for the PIX works lik a floating staticThanksHarris

I am in need of some real help here. I have to setup a Cisco Pix 501 firewall at work. First I guess it would help to know my setup and what it is that I would like to do:Cisco 678 router is my gateway 65.xxx.xxx.14then I want to have the following d...

Hi, I heard that with the latest cisco ios 6.x we could map a single private ip address with many private ip address like we do nat overload in the cisco router. Is it true and if so how it can be done. Thanks in Advance J.Karthik

I have not been able to find anything allowing me to perform the following.I need to PAT a subnet residing on the outside interface when making a connection to a specific host (host A) reacheable via the inside interface. I don't want the outside add...

Can you suggest a method to configure the PIX 315e firewall to handle Internet (VPN) connections and at the same time allow us to utilize our Public IP addressing scheme for our interion LANs (i.e. 130.xxx.xxx.xxx)? The Internet host PCs will utilize...

This question is a little bit odd, but I need the answer. I have two external interfaces on PIX (extranet1 and extranet2) and one route for the network 192.168.1.0 pointing to extranet1. That is OK. Now, I need to route traffic to two hosts which are...

One question it is posible to separate 2 networks with a PIX Firewall ...????There is not a routers only switches...

Hi Everyone, have a question, I have 3 different subnets from my isp. What I need to know is if the pix can handle the 3 different subnets or do I need a pix for each subnet. I want to disable nat, and have the machines using external address, with a...

I am trying to setup an external router to advertise a default route with OSPF through a PIX to an inside router using 'default-information originate' (not always), this way the internal router will switch to a floating default static route pointing ...

I have a new installation of a pix 525. We currently use Exchange 5.5 in our secure side network, behind a AS400 firewall. in the Exchange setup we had routed all outgoing mail through the AS400 firewall. Is there any setup involved in the new pix? S...

Is anyone else having issues with a 4210 sensor 3.1(2)S23 using shun command on pix 515 version 6.2.(1)? Worked fine until pix OS was upgraded.Anything diffrent that needs to be done?Thanks,Aaron

I have a web server inside a DMZ and an FTP server on the inside interface...and I can't get the web server to connect to the FTP server. My config is:ip address outside 62.3.2.162 255.255.255.224ip address inside 192.168.3.1 255.255.255.0ip address ...

Hi community,Does anybody know if it's possible to control an internal Pix interface via SNMP from an HP OpenView Management station ? Any doc link is also appreciated!Thanks for helping