Many to One NAT configuration with Stratix 5950

[DebasishMukhopadhyay91877]

I am trying to setup my Stratix 5950 switch for Many to One NAT configuration using NAT rules in ASDM wizard.

My Inside1 interface is already configured for VLAN 10 with IP 192.168.10.xx. The Outside Interface1 at 192.168.20. xx has a PC connected with IP 192.168.20.149 which needs to connect to all devices in VLAN 192.168.10.XX subnet.

What would be my NAT Rule Action criteria? Here are my choices:

Source NAT Type: Static, Dynamic, Dynamic(PAT). Shall I select "Dynamic"?

Source address: Shall I create a Network Object with a range. Example: 192.168.10. 2 - 192.168.10.254?

Destination Address: Shall I leave it to "Original"?

Any help would be appreciated. Please let me know if need additional details.

Thanks,

Dev

[balaji.bandi]

Stratix 5950- not sure is thus cisco product.

anyway, if both the side RFC 1918 address only for internal use  I go with 

Destination Address: Shall I leave it to "Original"?