01-23-2024 09:35 PM
we have to configure FTD 3105 firewall but we do not have SFP module for management port
so we are planning to use one of the ethernet ports(eth0-eth8) as the management port but found no article
is there any article or can anyone help us with steps and commands
01-24-2024 12:38 AM
I dont know but first time needed management interface then you can config data interface as mgmt.
Is this new fpr ?
MHM
01-24-2024 04:44 AM
For out of the box first time setup you need to use either the management interface (requires an SFP as you noted) or the console interface.
Once you are connected to FTD via console you can use this command:
configure network management-data-interface
06-10-2024 02:46 AM
@Marvin Rhoads I am trying to configure Eth1/1 & Eth1/2 as Failover and state link in FTD-3105 on both active and standby ,but it is not displayed in the list while creating HA. Only interfaces from Eth1/3 is displayed..? Also if I etherchannel eth1/1 & 1/2 that portchannel doesn't displays in the list...Any specific reason..?
06-10-2024 07:01 AM
@titusroz03 to use an interface (individual or portchannel) as failover or state link, it must first have no configuration (no nameif, no ip address, etc.)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide