Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I would like to bring up an issue which we are facing for a long period and couldn't find a solution.Users are getting disconnected from wifi randomly and we have to forget the SSID and reconnect. Somtimes it reconnects automatically but tak...
Dear All ,We have build a VPC setup between our Border leafs and Fortigate firewall like the below diagram. But we have brought this as pure L2 and yet to configure it as L3. Fortigate is not bringing the aggregate interface up untill we dsiable the ...
We are working on migration process were we are changing the OSPF neighbours. What is the process for clearing ospf process when migrating to new neighbour in both ACI gui and leaf and how can we troubleshoot the same..?
Dear All,We have planned for a Migration of our WAN connectivity from MPLS to SD WAN, in this our current mpls setup we have direct connectivity from our border leafs to mpls routers like below, which is an active-active setup in OSPF neighbourship.N...
Hi Team, We have an FTD which have an inside interface connect to our LAN switch, this interface is segregated through subinterfaces for DATA and AUDIOCODE vlan and both come under same security zone as seen below.We have both policy and nat rule for...
@aleabrahao Does meraki have predictive heat map analysis like we have in catalyst..? Does the predective heat map will narrow down to fix this issue..
@william111ttt We have disabled the 802.11r and created a TEST SSID, even after doing it the above log came in the TEST_CORP SSID with 802.11 disconnected. We upgraded to the latest 32.1.7 even though it didn't resolve. But once I disabled the Fast r...
@aleabrahao @Stefan Mihajlov @Raphael_L @Mark Elsen I have disabled the 802.11r with the new Test SSID, and there wasn't much disconnections in roaming post that for one week. but again oneuser was disconnected and bouncing between the Aps..This time...
Dear All,Can some one give an idea about Re-auth in WPA2 - Radius(802.1X) in meraki. Reasonf for a endpoint to re-auth should be if it roams to another AP or reboots the machine right..? In Meraki we have a Re-auth timer override settings when we con...
