02-02-2007 02:49 PM - edited 03-11-2019 02:28 AM
how many FWSM can be configured on 6513 and whcih command is used to propagate between each FWSM the session slot..... command is not working.
02-02-2007 08:24 PM
Hi,
below link describes slot availability for FWSM installation.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/hwinstgd.htm#wp35720
To session in to the FWSM from the switch, log in, access privileged mode, and then configuration mode and perform the following steps:
CAT6513# session slot number processor 1
e.g # session slot 9 processor 1
HTH
gagan
02-03-2007 01:04 AM
Friend
You can install 4 FWSM modules in a single chassis
http://www.cisco.com/en/US/products/hw/modules/ps2706/ps4452/index.html
gagan has already posted the way to log on to the different modules
HTH, rate if it does
Narayan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide