cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1949
Views
0
Helpful
1
Replies

PIX 506 w/ PPPoE (DSL) and 1 IP address

jblancaster
Level 1
Level 1

I have a PIX506 6.01 and would like to use it on my DSL but I only have 1 IP address and must connect w/ PPPoE. Is there a way to do this? Has anyone done it? My only alternative is to change service providers.

1 Reply 1

bdube
Level 2
Level 2

You can use a gateway, like the D-Link's DI-701 or DI-704 to manage PPPoE and provide static addresses for inside network (internal to DLink) and dynamic address for outside network (ISP side).

Review Cisco Networking for a $25 gift card