Network Security

Taking the example of the vpn3002, when it is configured as dhcp client, the number of retries is infinite.In the case of pix , the number of retries as dhcp client is from 4 to 16, it force to reload(unplug and plug the power cord) or via the CLI (w...

Dear All:I would like to know PIX support central manager and policy dispatch , Because i had 200 PIX 501 in branch office and i want manager and policy dispatch in headquarter

The PIX 501 documentation states that it supports a maximum of 5 simultaneous IKE SA's. Does this number refer to the IPSEC sessions that are terminated by the PIX? If I am not terminating these sessions at the PIX and instead use VPN client software...

Can i configure VLANs type 802.1q on the PIX Firewall with the o.s. ver. 6.2 ?Thanks in advance

I'm using a PIX 515 running 6.2 IOS with 3 ports. I have a W2K VPN Server in the DMZ interface that I would like to our W2K client to conntect to. Is this possible? If this is possible what do I have to do? I have setup a vpn connection using to PIX ...

Can I assign two different IP addresses from two different subnets to the same interface on PIX?ThanksS.

How can I timeout idle local hosts in pix 501 with 10 users license so that the new connections in the network can be given access.

I issued the show failover command on my primary pix box. It showed two of the three interfaces in normal mode, but the third ( a vpn tunnel) was in test mode. I was able to ping, and send traffic successfully going through the third interface; but ...

Does anyone know if it's possible to route traffic based on type (ie HTTP, SMTP) to a specific interface. We have one ISP connection connected to the Outside interface and another ISP connected to the DMZ interface. We'd like to force all out/inbou...

I want users to be able to surf the Internet, but not be able to download files.Is this possible?? Is there a protocol I can block?

I'm implementing a PIX 525 (2 interfaces only) and forcing all net and internally untrusted traffic through it ("PIX on a stick")--Is this feasible? How many users can I (NA) translate efficiently on a PIX?

I want to block users from using internet radio stations. What is the most efficient way to do this with a PIX?

How can I enable CDP Protocol over aPIX firewall ?

according to PIX Installation Guide, you can have up to 8 interfaces on a PIX 525 (see Note at URL : http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_61/pix_ig/pix525.htm#xtocid11according to PIX Configuration Guide, you can have up to 6...

In a failover configuration, if I do a show fail on the active PIX, I see thisfor the cable status for the insideinterface on the secondary host:Interface Inside(10.0.0.2):Testing.On the active PIX the status is normal and if I look on the secondary ...