PIX and DSCP values
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2007 12:41 AM - edited 03-11-2019 03:11 AM
Does the PIX reset the QoS DSCP values in the IP packets through it?
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-11-2007 09:05 AM
Only 7.x and up will support QoS. Any version prior to that will drop the TOS flag within the IP header.
Thanks,
Chad
Please rate if this helps!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2007 01:28 AM
I have a 7.x version, and I mark the DSCP value before the packet enter into the pix and when the packet goes out the DSCP values is 0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2007 04:24 AM
Did you configure a QoS policy? QoS is not just turned on.
7.2 QoS Policy:
Thanks,
Chad
