08-27-2018 05:01 AM - edited 03-12-2019 06:55 AM
Hi,
I try to configure Port-channel and HA failover on Cisco 2130, but without result (((
I could not find how to do this via FTD Manager and CLI (fxos or ftd).
I could not find the documentation for this model about it.
Is it possible?
Solved! Go to Solution.
08-28-2018 02:16 AM
Etherchannel and HA configuration requires that you use FMC - not FDM or FX-OS cli.
Here is documentation confirming the Etherchannel bit:
The HA bit is covered in product training (and is probably in a Cisco Live presentation as well).
This is the current limitation as of release 6.2.3. It may change in the future.
08-28-2018 02:16 AM
Etherchannel and HA configuration requires that you use FMC - not FDM or FX-OS cli.
Here is documentation confirming the Etherchannel bit:
The HA bit is covered in product training (and is probably in a Cisco Live presentation as well).
This is the current limitation as of release 6.2.3. It may change in the future.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide