03-05-2019 01:39 AM - edited 02-21-2020 08:53 AM
Hello Expert,
I try to configure Port-channel on Cisco firepower 2130.
The client Device is managed localy.
Is there a way to create Port-channel on 2130 via cli ?
Regards,
Zanga
Solved! Go to Solution.
03-05-2019 05:25 AM
The limitation correctly noted by @Ilkin is documented in the FDM Configuration Guide:
It remains so even as of the most recent 6.3 release. Expect this to change in the future but that's how it is for now.
Regarding cli, one cannot perform configure type cli commands from any FTD device - that applies whether it locally managed with FDM or via an FMC.
When a command or configuration is supported in FDM it is generally an indicator that there is an API for it on the device. FDM communicates to the managed device via the REST API.
03-05-2019 02:32 AM
Hi Zanga,
Currently a port-channel interface on Firepower 2100 running FTD code can be configured only using Firepower Management Center.
03-05-2019 05:25 AM
The limitation correctly noted by @Ilkin is documented in the FDM Configuration Guide:
It remains so even as of the most recent 6.3 release. Expect this to change in the future but that's how it is for now.
Regarding cli, one cannot perform configure type cli commands from any FTD device - that applies whether it locally managed with FDM or via an FMC.
When a command or configuration is supported in FDM it is generally an indicator that there is an API for it on the device. FDM communicates to the managed device via the REST API.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide