Hello,
I currently have the ASA 5505 firewall set up to login through a DSL modem (passthrough mode). On the 5505, I set up my outside interface and vlan to connect via PPPoE and it seems to work fine.
I recently purchased an ASA 5508 and I've tried to set up PPPoE client on the GigaBitEthernet 0.1
In brief, when the DSL negotiates, I don't see any attempts for the ASA 5508 to connect. It just doesn't budge.
I don't have any routes defined, but I assume it should still connect even without a route?
And, is there something different now because the PPPoE is not being defined on a vlan?
Perhaps I'm new to the 5508-x and I don't understand some basic fundamentals.
Any suggestions are welcome.
Thanks.
