Hi,
Each time I try to insert the VPN Acceleration Module 2 (SA-VAM2) into the Cisco 7206 router, i'm keep getting this error.
:43:09.438:: %VPN_HW-1-INITFAIL: Slot 6: No response to download in 50000 milliseconds
:43:09.438:: %VPN_HW-6-SHUTDOWN: VAM2 shutting down
But when i show diag, i can see that the router detects the module as below but it does not performance the encryption.
Slot 6:
VAM2 Encryption/Compression engine, Port adapter
Port adapter is analyzed
Port adapter insertion time 3d23h ago
EEPROM contents at hardware discovery:
Hardware Revision : 2.0
PCB Serial Number : JAB074706SA
Part Number : 73-8491-02
Board Revision : A0
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Deviation Number : 0-0
Product (FRU) Number : SA-VAM2
Top Assy. Part Number : 800-22836-02
CLEI Code :
Version Identifier : V
Unknown Field (type 0020): FF
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 03 E4 41 02 00 C1 8B 4A 41 42 30 37 34 <ommitted>
Below is my router spec:
Cisco 7206VXR (NPE-G1) processor (revision A) with 491520K/32768K bytes of memory.
Processor board ID 31411314
SB-1 CPU at 700MHz, Implementation 1025, Rev 0.2, 512KB L2 Cache
6 slot VXR midplane, Version 2.7
Last reset from power-on
PCI bus mb1 has 0 bandwidth points
PCI bus mb2 has 600 bandwidth points
3 Gigabit Ethernet interfaces
264 Serial interfaces
8 Channelized E1/PRI ports
1 Integrated service adapter
509K bytes of NVRAM.
62976K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).
16384K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x210
Even when i run the feature navigator this module supported by the current image but why do i get this error? How to activate this module?
regards,
Ganesh
Systems Engineer
