01-04-2011 09:15 AM - edited 03-11-2019 12:30 PM
I currently have a site to site tunnel configured between a Pix 515e and ASA 5520. I am currently tunneling traffic from two interfaces on the ASA 5520 to the Pix 515e. Does anyone know if you can tunnel traffic from the Management 0/0 interface of the ASA 5520 to the Pix 515e? I have not been able to get it to work. I have applied the no management-only command on the Management 0/0 interface.
01-04-2011 11:05 AM
This is expected behavior, traffic will not flow through the interface Management unless it is defined as no management interface.
01-04-2011 11:21 AM
On the Management Interface, I have issues the no management-only command. Is there something else I need to do to remove the management only functions?
01-04-2011 11:23 AM
Just issueing "no management-only" should allow traffic to go through, assuming all other setting are complete.
01-04-2011 11:32 AM
I can access devices on the Management 0/0 interface from the Inside Interface, so the Managament Interface is passing traffic. Any other ideas?
01-04-2011 11:34 AM
So what happens is that traffic that is on the management interface cannot reach the network on the 515 side via de vpn tunnel so far? if that is the case, do you have the proper crypto acls and no nat statements defined? can you post your config?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide