12-17-2007 08:45 AM - edited 03-12-2019 05:51 PM
I have a hardware VPN tunnel from a PIX515e to a PIX501. Traffic in the tunnle is very bad. If I do a "sh crypto isakmp sa" is shows a state of "QM_IDLE". I am not sure if this is a problem? The any ideas on how I can troubleshoot this?
12-17-2007 09:20 AM
What code are you running ont he PIX515E 6.3 or 7.x ? I had the same issue after I upgraded a pix515e to pix code 7.x. I tried 7.1 and 7.2 code. Everything through a vpn tunnel from another pix 501 was really slow. I downgraded back to 6.3(5) and the tunnels performance was back to normal. (I was going off by what the remote users were saying about there application speeds) Remote vpn's didn't seem to be affected only L2L vpns.
12-17-2007 09:25 AM
Thanks for your reply. The 515 is Ver 6.3(4) and the 515 is 6.2(2). I was thinking of doing an upgrade to the 501. From your post your 501's are on 6.3(5). I will upgrade and let you know.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide