- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 04:37 AM - edited 02-21-2020 08:36 AM
Hello Team,
Getting below error in FMC
"there are no smart licensed devices currently being managed by the system. please go to device device management to add a smart licensed device" whereas the FMC and Smart license portal are synchronized..
Cisco ASA5516
Pls help as earlier it was working perfectly suddenly it is showing the license unregistered..
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 05:22 AM - edited 12-28-2018 05:23 AM
Hi,
As per your license portal you are utilising 4 Threat & 4 Malware licenses and 1 vFMC.
So all your 4 FTD's are registered to this vFMC right...??
Try rebooting the vFMC and check or else Please open a ticket with cisco as your FTD's are in production.
Thanks,
Abheesh
PS: Please don't forget to rate and select as validated answer if this answered your question
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 04:42 AM - edited 12-28-2018 04:43 AM
Are you added any FTD in FMC..?
As per you license page there is no base license utilised.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 04:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 04:51 AM - edited 12-28-2018 04:52 AM
Is it in production or staging..? Try re-register with FMC, while re-register you need to configure again the interface, routing configuration and bind ACP to FTD
HTH
Abheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 04:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 04:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 05:16 AM
Thanks for reply..
On behalf on Anil sir , I am attaching screen shots of cisco smart account..
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2018 05:22 AM - edited 12-28-2018 05:23 AM
Hi,
As per your license portal you are utilising 4 Threat & 4 Malware licenses and 1 vFMC.
So all your 4 FTD's are registered to this vFMC right...??
Try rebooting the vFMC and check or else Please open a ticket with cisco as your FTD's are in production.
Thanks,
Abheesh
PS: Please don't forget to rate and select as validated answer if this answered your question
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2019 01:47 AM
