cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2833
Views
0
Helpful
3
Replies

SNMP Configuration on FMC

Hello, 

 

I would like to ask how could I configure SNMP in FMC for the firepower devices(2110). 

 

As I searched there are 3 places with SNMP configurations. 

1) System>Configuration (It is used for the FMC to be polled)

2) Devices>Platform Settings>Policy>SNMP (It is used for the devices to be polled)

3) Devices>Device Management>Inside a group of a device>SNMP (What is this for?) 

 

My goal is to send statistics from a specific interface to the SNMP server. I have configured the 2) but the output of the info does not show anything for the interface. 

 

Could you help clarify the different SNMP configs?

 

Regards, 

Konstantinos

1 Accepted Solution

Accepted Solutions

if this resolved can you mark as resolved, so use full for other community users.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

here is the SNMP configuration :

 

https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/213971-configure-snmp-on-firepower-ngfw-applian.html

 

Worth checking any log while poll take place from NMS Server to device in Analysys logs what is the errors ?

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Thank you BB, 

 

It seems that the problem was on the server side. 

It is working now.

 

Regards,

Konstantinos

if this resolved can you mark as resolved, so use full for other community users.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Review Cisco Networking for a $25 gift card