03-13-2017 09:49 AM - edited 02-21-2020 06:02 AM
I have a Firepower 4110 appliance running FTD v6.2. I can configure SNMP through the FMC at Devices -> Platform Settings -> SNMP. This allows me to perform SNMP queries to any of the data interfaces of the appliance, if I allow a "host" access to that interface. However, it does not allow me to send my SNMP polling to the management interface. The management interface is simply not in the list of possibilities for me to allow SNMP access to. Why not? The out-of-band management segment is where my SNMP monitoring system is based and SNMP and other management functions is obviously exactly what the management interface exists for. How can I do SNMP monitoring of the FTD to the management IP address?
Solved! Go to Solution.
03-31-2017 08:36 PM
You can (and should) allocate a physical interface from among those on the chassis for the logical device's management interface.
That is distinct from the chassis management interface which is primarily to access the chassis FX-OS (used for command line interface and FirePOWER Chassis Manager graphical user interface of the appliance chassis)
06-28-2017 06:32 AM
I am not sure if I should create a new topic - but question is how to set up SNMP on the Cisco ASA5500X running Unified image FTD manage from FTD device manager , not FMC
i am currently running 6.2.0.2-51
06-28-2017 07:20 AM
FirePOWER Device Manager does not currently (as of 6.2.0.2) allow you to setup SNMP management of an FTD device.
If you require that feature you need to use FMC.
11-09-2018 10:37 AM
Hi I have 4 FTD devices attached to single policy under platform settings in FMC, i want to enable SNMP monitoring to all of the 4 FTD devices,if i am creating diagnostic interface which ip address do i need to assign all 4 boxes has different-different management interface ips.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide