06-03-2022 08:00 AM
Good morning, I notice each time I log into my FMC, I have a deployment task pending. Upon checking the task details, it's always the rule updates that have been downloaded but not applied to my FTD appliances. I have to manually deploy this each time. I am still new to FMC and was wondering if I check the below setting under Rule Updates, would this automatically apply the rules when they are downloaded?
Solved! Go to Solution.
06-03-2022 08:16 AM
Yes it will do exactly that.
Some users choose not to tick that box since the deployment will include any other changes that are pending. Depending on your environment, that may include other changes that are a work in progress and not ready or approved for deployment.
However if you are the only admin then it's usually not a problem to just allow the deployment.
06-03-2022 08:16 AM
Yes it will do exactly that.
Some users choose not to tick that box since the deployment will include any other changes that are pending. Depending on your environment, that may include other changes that are a work in progress and not ready or approved for deployment.
However if you are the only admin then it's usually not a problem to just allow the deployment.
06-04-2022 10:08 AM
Thank you Marvin
06-05-2022 01:44 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide