Syslog configuration on firepower module of standby asa

[engineer467]

Hello,

We have ASA's in active/standby with firepower modules.

I was able to configure syslog and snmp on module installed on active asa using ASDM.

But not sure how to do the same on module installed on standby asa as i can't connect to secondary asa using ASDM.

Does the configuration gets automatically replicated from primary to secondary module? 

Please help.

Thank you.

[balaji.bandi · Accepted solution]

yes, most of the configuration will be automatically synced with standby.

[engineer467]

Thanks for the answer.

Is there any document from cisco where I can get information regarding this, cz I have few more queries :)

[balaji.bandi]

here is the document for reference (ignore the version f you have higher)

https://www.cisco.com/c/en/us/td/docs/security/asa/asa95/configuration/general/asa-95-general-config/ha-failover.html

[engineer467]

You were right, most of the configuration got replicated, not all. Had to configure few things again on the standby module.

Thank you for the replies.