06-02-2020 03:56 AM
Hello,
We have ASA's in active/standby with firepower modules.
I was able to configure syslog and snmp on module installed on active asa using ASDM.
But not sure how to do the same on module installed on standby asa as i can't connect to secondary asa using ASDM.
Does the configuration gets automatically replicated from primary to secondary module?
Please help.
Thank you.
Solved! Go to Solution.
06-02-2020 10:33 AM
yes, most of the configuration will be automatically synced with standby.
06-02-2020 10:33 AM
yes, most of the configuration will be automatically synced with standby.
06-02-2020 11:10 PM
Thanks for the answer.
Is there any document from cisco where I can get information regarding this, cz I have few more queries :)
06-03-2020 12:36 AM
here is the document for reference (ignore the version f you have higher)
06-03-2020 10:54 PM
You were right, most of the configuration got replicated, not all. Had to configure few things again on the standby module.
Thank you for the replies.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide