cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
321
Views
1
Helpful
3
Replies

#Threat-Detection Basic-Threat on FTD

Monadnock
Beginner
Beginner

 Hi, I have an audit that is picking up on the threat-detection CLI from an FTD show run and asking to change this:

#threat-detection basic-threat

to

#threat-detection advanced-threat

I obviously can't configure that within CLI and I don't see anywhere in the GUI to change threat-detection level to basic. I'm also a bit confused on all of the commands there - are they remnants of ASAs? Is packet rate limiting not done via Network Access Policy and/or the advanced tab under Access Control Policy?

Thanks!

1 Accepted Solution

Accepted Solutions

#Mat
Frequent Contributor
Frequent Contributor

I've tried it in my lab FMC 7.0 and it didn't work. I wasn't able to change that configuration with Flexconfig.

 
.

View solution in original post

3 Replies 3

#Mat
Frequent Contributor
Frequent Contributor

Hi @Monadnock,

Yes, the service policy is in advanced settings. Have you tried with flexconfig?

Regards,

.

#Mat
Frequent Contributor
Frequent Contributor

I've tried it in my lab FMC 7.0 and it didn't work. I wasn't able to change that configuration with Flexconfig.

 
.

that's helpful thanks, I couldn't even find any documentation showing what that command would even do

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: