03-02-2004 05:40 AM - edited 02-20-2020 11:16 PM
IS there any web interface to config PIX??
Thx ^^
03-02-2004 05:05 PM
Sure, PIX Device Manager (PDM) has been around for quite a while now. If you have a recent PIX the software should already be installed, especially on the 501/506 line. Do a "sho ver" and if the second line of output says "PIX Device Manager ...." then the software is already there.
If not, you can get the software from here:
http://www.cisco.com/cgi-bin/tablebuild.pl/pix
and read the install notes here:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pdm/index.htm
Have fun.
03-02-2004 05:33 PM
Thx Reply
I check my PIX, PDM (1.1.2) has been installed before
but how to access it by web? ( After I read the note, I don't understand)
Thx ^^
03-18-2004 06:51 AM
in your web browser "http://ip address of pix inside interface" or change inside interface to management interface if you have one. I would suggest upgrading the pix OS and PDM two different downloads.
03-24-2004 04:48 AM
03-24-2004 05:09 AM
The following commands should be issued.
http server enable
http (ip address of workstation pdm is to be used from) 255.255.255.255 inside
pdm location (ip address of workstation pdm is to be used from) 255.255.255.255 inside
That hoepfully should get you working.
03-24-2004 07:25 AM
Thx!! It works now
pdm location (ip address of workstation pdm is to be used from) 255.255.255.255 inside <= what is that mean??
03-24-2004 10:21 AM
In pdm 3.0(1) another command is added that is pdm location that addresses locations where pdm is available from. the mask 255.255.255.255 means only this address and only the inside interface.
03-25-2004 07:26 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide