Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running a PIX and one of my internal users needs to VPN to an external customer's site where they use a Contivity. The nortel docs they sent me were useless, so I'm looking for someone with knowledge of what ports/protocols I need to permit so t...
My company uses a dial-out application called Remoteware by Xcellenet (www.xcellenet.com). This app does not support com port redirection, and we are currently considering implementing call managers to replace our legacy PBX. Are FXS ports on a 650...
We've had a couple of MWI issues after doing maintenance. Now, whenever we do any maintenance I run the Cisco Unity > Manage Integrations utility. On the Properties page there is a MWI Synchronization option. I am not sure if/how this could be rel...
As far as I know PIX does not support subinterfaces. It definately does not understand dot1q or ISL trunking.http://www.cisco.com/warp/customer/110/pixfaq.shtml
Yes, you can set the ip address on the vlan interface this way, and the other address (the one you added by mistake) will be overwritten. From the CLI (console connection)switch# conf tswitch# int vlan1switch# in address Good luck.Jon
