cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
839
Views
5
Helpful
2
Comments
Meddane
VIP
VIP

Question 1: What are the OSPF Loop Prevention Mechanisms

Question 2: Why area 0 is required?

Question 3: what is the command to stop Type-7 LSA ?

Question 4: How the NSSA ABR translator election occurs?

Question 5: How to stop receiving specific subnets In NSSA?

Question 6: What does it mean the priority 0 in Broadcast Network?

Question 7: In OSPF, why E1 routes are preferred over E2 routes ?

Question 8: In OSPF, what is forwarding address ?

Question 9: What is the partition of the backbone area 0 ?

Question 10: Why an NSSA ABR does not inject a default route automatically?

Question 11: OSPF Link State or Vector Distance Routing Protocol?

Question 12: What is the path selection order in OSPF?

Question 13: How to suppress the Forward Address using two methods?

Question 14: Is a loop possible in OSPF?

Question 15: Can an interface belong to multiple area?

Question 16: How to inject a Type-7 LSA Default route on an NSSA ASBR?

Question 17: Why filtering using the distribute-list is only valid on ASBR?

Question 18: If only a non-OSPF route to the Forward Address exists in the RIB, can a router use it to install the external route?

Question 19: If two ASBRs inject a default route into OSPF domain, is there a risk of loop?

Question 20: Why the P-bit must be cleared in the Type-7 default route originated by an NSSA ABR?

2 Comments

Yes waiting your prefect answer. 
thanks a lot.

Meddane
VIP
VIP
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: