Multicast-Routing in IPv6 environment is explicitly enabeled in Global Configuration mode by command "ipv6 multicast-routing". The effect of this command is seen on all IPv6-enabled interfaces on the router which are then automatically enabled also for PIMv6. As this is the default configuration of each interface, the ipv6 pim command is assumed and does not appear in the interface configuration. When PIMv6 is enabled on an interface, the
interface always operates in sparse mode. PIM-SM (Sparse-Mode) uses unicast routing to provide reverse-path information for multicast tree building, but it is not dependent on any particular unicast routing protocol.
Note: To disable PIM on a particular interface, command used is "no ipv6 pim" (interface level).
Understanding Of Multicast Concepts
Understanding of IPv6 Addressing
Understanding of IPv6 OSPF Routing Protocol
In this document, Router R1, R2 and R3 are enabled with PIM-SM (Sparse Mode), command "ipv6 multicast-routing". . They are also configured with IPv6 OSPF unicast routing. A multicast group is created on R1 and is configured to be a respondent for this group by interface level command "ipv6 mld join-group FF08::10". We are configuring Router R3 to be the Rendezvous Point for this group.
Note: All configuration is tested on Cisco 7200 Series Router running on IOS Version 15.1(3)S3 Advance IP Services Image.
Hi,I‘m planning to use a C9300 as a layer 3 switch... probably someone can tell me which Parameters (switching bandwidth, forwarding rate, etc.) I should pay attention to and understand why, so that I don‘t get any performance problems?thank you for your ...
Hi all We have a fairly simple network, but I now want to add a separate vlan 20 for guest traffic. Until now, we have not had any vlans configured. We have wireless access points and they can attach an SSID to a VLAN. This is working correctly ...
Good Afternoon Brains Trust. I have just completed a fresh install of Cisco Prime 3.9 on both my Primary and Secondary PI servers.I've set up HA in the past on 3.7 with no issues, however when I followed the same procedure on 3.9 I have found that I ...
HiI have been using Packet Tracer for a long time. I first used it on Windows 7 and it was all O.K.Now that I bought a new PC with Windows 10 (last ver.) I have a problem that the association with the pkt extension of my files only runs an empty Packet Tr...
Currently doing a bgp rpki topology and set up an ubuntu server with an rpki validator and everything is working. Now, trying to connect my bgp routers to the rpki validator. I enter router bgp <as number> Then Device(confi...