Hi, I want to create script to just a copy running-config to tftp server. Or anyone knows command to execute the same task without prompting for input.I am running following command on cisco ASA box.#copy running-config tftp:<IP address>/<di...
view more
Hi All, Trying to backup our cisco asas with following event manager script: Event manager applet weeklybackupevent timer watchdog time 604800action 0 cli command "enable"action 1 cli command "copy /noconfirm run disk0://weekly-backup" is t...
view more
Hello, i have 9k switches, and CSSM Satelite for SMART licensing .The switches was successfully registered to CSSM until yesterday. On every device, we had shown : Registration expired : 29.5.2020. 14:59After that time, all devices went to...
view more
After hours of trying to make this switch work, watching cisco videos, reading posts etc, i have come to the conclusion that it is Layer 3 Lite, and incapable of providing inter VLAN communications within the switch. The switch cannot operate on Layer 3 m...
view more
I cannot seem to get a basic NAT64 configuration working on a Cisco 4321. The config has been reset; and only the following changes: ipv6 unicast-routing!interface Loopback0 ip address 8.8.8.8 255.255.255.255!interface GigabitEthernet0/0/0 desc...
view more
