How can I edit or remove pending config from NDFC

[Axis-CP]

Hi there,

I have been asked to push some interface configuration changes to 4 switches via NDFC. Currently, all 4 switches show as Out-of-Sync and when I select preview, I see the following Pending config:

logging server 10.xxx.x.xxx 7 port 9515 use-vrf prod
terminal dont-expunge
no interface Vlan2704
configure terminal

As far as I'm aware, that logging server command should not be deployed, and I definitely do not want to remove the VLAN interface. I'm not sure why configure terminal is there, and I'm also not sure what the terminal dont-expunge command does.

Regardless, is there a way from NDFC I can edit or remove this pending config so that the switches appear in sync and I can deploy changes without pushing these unwanted commands?

Thank in advance.

[michael.jaeger]

Hello,

So we have the same Problem i show  you our config for deliver:
no vlan 1
ip route 0.0.0.0/0 192.168.xxx.1
exit
interface mgmt0
vrf member management
ip address 192.168.xxx.yyy
no shutdown
no cdp enable
configure terminal

None of us wants to delete the vlan1 but we cannot delete the config to be delivered. therefore a switch is always our-of-sync

[Sarah.Hussein]

Hello,

we have the same issue for interface that are not on the SWs (cards are not installed) and I reported the issue but nobody replied till now, hopefully that we get a reply here

Regards

[mrflorida]

I have seen this too.. You need to do a "recalculate and deploy" on the fabric in NDFC.

[Sarah.Hussein]

thanks so much