cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
550
Views
10
Helpful
4
Replies

NSO Itential tool package load error

S_Singh
Level 1
Level 1

Would appreciate any help on this error

init:boot_msg: "Bad configuration: /etc/ncs/ncs.conf:0: /nso/run/state/packages-in-use/1/itential-tools/load-dir/itential_tools.fxs: Must be recompiled!\n"
Waiting for NSO to start...
run-nso.sh: NSO is dead (exit code 21) - exiting container

4 Replies 4

vleijon
Cisco Employee
Cisco Employee
That means that you are trying to start the system on a new NSO version without rebuilding and reloading the packages.

This is a new NSO setup where I'm trying to add this package. And, it is giving the error when I do package reload 

please have a look on the error 

admin@ncs# packages reload force

>>> System upgrade is starting.
>>> Sessions in configure mode must exit to operational mode.
>>> No configuration changes can be performed until upgrade has completed.
>>> System upgrade has been cancelled.
Error: Internal error: {failed,
{recompile_needed,
"/nso/run/state/packages-in-use/1/itential-tools/load-dir/itential_tools.fxs"}}
admin@ncs#
System message at 2022-09-21 15:03:39...
Subsystem stopped: ncs-dp-2-cisco-ios-cli-3.8:IOSDp
admin@ncs#
System message at 2022-09-21 15:03:39...
Subsystem stopped: ncs-dp-1-cisco-ios-cli-3.8:IOSDp2

The error message means that the package is compiled with another NSO version than is currently running.

S_Singh
Level 1
Level 1

Thankyou so much @vleijon for your response. 

it is working after make clean

S_Singh_1-1663773579349.png

 

 
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the NSO Developer community: