05-22-2017 12:37 AM - edited 03-01-2019 03:50 AM
I am trying to follow the example for NSO manual-ha
When i execute below command from n1 folder
NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
CDB boot error: failed to load ./ncs-cdb/ncs_init.xml:3: unknown namespace: http://tailf.com/ha in ha-config
Daemon died status=10
Solved! Go to Solution.
05-24-2017 02:43 PM
Kirti,
In this example, it seems that if an attempt is made to start ncs in ha/n1 directory prior to doing the 'make all' you get this error:
n1$ NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
CDB boot error: failed to load ./ncs-cdb/ncs_init.xml:4: unknown namespace: http://tailf.com/ha in ha-config
Daemon died status=10
Then do a 'make all' - without doing a 'make clean' first, you get into this state:
n1$ NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
CDB boot error: failed to load ./ncs-cdb/ncs_init.xml:4: unknown namespace: http://tailf.com/ha in ha-config
Daemon died status=10
Do the following to successfully get NCS running in ha/n1 dir:
1) 'make clean' in ha directory
2) 'make all'
3) start ncs in ha/n1:
n1$ NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
n1$ NCS_IPC_PORT=5757 ncs_cli -u admin
admin connected from 127.0.0.1 using console on GB6B
admin@GB6B>
05-24-2017 02:43 PM
Kirti,
In this example, it seems that if an attempt is made to start ncs in ha/n1 directory prior to doing the 'make all' you get this error:
n1$ NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
CDB boot error: failed to load ./ncs-cdb/ncs_init.xml:4: unknown namespace: http://tailf.com/ha in ha-config
Daemon died status=10
Then do a 'make all' - without doing a 'make clean' first, you get into this state:
n1$ NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
CDB boot error: failed to load ./ncs-cdb/ncs_init.xml:4: unknown namespace: http://tailf.com/ha in ha-config
Daemon died status=10
Do the following to successfully get NCS running in ha/n1 dir:
1) 'make clean' in ha directory
2) 'make all'
3) start ncs in ha/n1:
n1$ NCS_IPC_PORT=5757 sname=n1 NCS_HA_NODE=n1 ncs -c ncs.conf
n1$ NCS_IPC_PORT=5757 ncs_cli -u admin
admin connected from 127.0.0.1 using console on GB6B
admin@GB6B>
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide