Mix SFP-10G-SR and SFP-10G-SR-S

[Hubsi-Smith]

Hello,
I have an question about the SFP-10G transceiver. For example, I have two Cisco switches, one has an SFP-10G-SR and the other one has an SFP-10G-SR-S transceiver. Would this work in a productive environment?

[Hubsi-Smith]

I have forgotten, I would use them only for Ethernet

[Kasun Bandara]

yes it will work. 

note - for non-S SFPs, below are the limitations. normally these are not an issue for general environments.

• OTN or WAN-PHY support

• Optics deployed in non-temperature controlled environments, e.g. rugged/ industrial (RGD)

• Optics plugged on platforms that require extended operating temperature range (EXT)

• TAA compliance