10-22-2019 10:42 PM
Hi All,
I have an older 7600 router that I would like to use to host NAT:
I have the following config:
ip nat inside source list 45 interface te5/5 overload
ip dhcp pool NAT
network 192.168.1.0 255.255.255.0
default-router 192.168.1.1
domain-name ‘test-nat.com’
lease 8
access-list 45 permit 192.168.1.0 0.0.0.25
int te5/4
description inside facing NAT/default DHCP router
ip address 192.168.1.1 255.255.255.0
ip nat inside
int te5/5
description outside facing NAT
ip address #public address
ip nat outside
10-22-2019 10:45 PM
As a bit of added info:
i can ping from the global IP,
and the DHCP is working to hand out local IPs just fine. However, it does not appear that NAT is functional.
show ip NAT statistics shows no translations and I cannot get any info from debugging (debug ip NAT with term mon enabled, right?)
11-04-2019 10:03 AM
Is this DTE equipment or DCE equipment? what side of the demarc is this why are you using a dhcp pool for nat could you please provide a diagrahn for your network or that portion of what you are trying to do
11-04-2019 10:08 AM
you need to add an ip nat translation command to translate all the inside addresses to the outside address
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide