Let me tell you the kind of setup i have in place.
PC(Using Microsoft Netmeeting)--(Connected to LAN)--->Cisco 3640-----T1-------> Nortel Network DMS250 switch(Tandem Switch)--->PSTN.
I am able to make a call using Microsoft Netmeeting. But the voice quality suffers badly when a user at the PSTN side tries to listen the user at the PC side. The user at the PC Side can listen the converstion at the PSTN side.
Can anybody help me configure the correct QoS for this setup. Thanks in advance.
i have the following been configured on the Cisco 3640:
controller T1 1/0
framing sf
linecode ami
ds0-group 0 timeslots 1-24 type e&m-wink-start
interface FastEthernet0/0
ip address x.x.x.x x.x.x.x
speed auto
full-duplex
no cdp enable
voice-port 1/0:0
echo-cancel coverage 32
bearer-cap 3100Hz
dial-peer voice 1 pots
destination-pattern ..........
direct-inward-dial
port 1/0:0
forward-digits all
dial-peer voice 4 voip
incoming called-number ..........
codec g711ulaw
fax rate disable
no vad
Looking forward to hear ....
Thanks,
Amit Sonik